http://www.rubiks.com/images/lvl4/produc/template/free_downloads/media/magic.rm
http://www.rubiks.com/images/lvl4/produc/template/free_downloads/media/magic.rm[此贴子已经被作者于2006-3-28 21:15:05编辑过]
换图案
http://www.rubiks.com/images/lvl4/produc/template/free_downloads/pdf/8panel_black_magic.pdf
http://www.rubiks.com/images/lvl4/produc/template/free_downloads/pdf/magic_red_orange.pdf
[此贴子已经被作者于2006-3-28 21:16:08编辑过]
我也来凑热闹一下
摘自：http://twistypuzzles.com/articles/magic-removestrings.shtml
We have a few articles devoted to the layout of magics and where the strings go, but the actual technique of how to remove or replace strings hasn't been addressed yet which is probably the fundamental barrier for someone wanting to try their hand at a custom magic.
I'll show the technique for removing and adding strings in just a few pictures. My beautiful hand model is Michelle, my wife. I would have done it myself, except that I had black ink all over my fingers which isn't terribly attractive.
1. To pull and guide the strings, I use a type of gift twine, or ribbon. It is flat but with some width, and it is smooth.
2. To start removing strings, get a piece of ribbon twine under both strands of nylon. From here pull gently up, stretching lightly. This also pulls a little slack from the other tiles towards the area being worked on. Please don't try this in a cold environment. Chances are, you'll snap the twine where the sleaves join. Do it in a warm environment to allow some flexability with the nylon strings.
3. Slide the two ribbons along under the tile into the corner so they meet together.
4. Turn the magic over. Again, start lightly stretching and pulling the string towards the corner tip.
5. Allow it to pop over but guide it completely over the pair of tiles so that the string doesn't get caught between the two tile waffers.
6. The string loop should be free and undamaged. Most likely, you can remove it from the three tiles it connects. If you can't remove it completely, simply move on to the next string. Eventually, the whole magic will collapse and you can remove all the loops. Keep the loops together over a bottle or something so they don't get lost or tangled up.
I suggest you read the other articles on Rubik's Magic layouts because it's tricky to work out the picture arrangements. Anyway, once your pattern is ready, you can assemble.
1. Most of the time, you should join 3 tiles at a time. Each set of three requires two loops of string at minimum. I tend to add the minimum amount of strings, then add others after the puzzle is complete and working. Get three tiles ready and get a loop of string. Hook the start of the loop under the tile.
2. Attach the start of the loop under the corner and add a blob of Blutack. Blutack is not very strong but it holds things temporarily in place.
3. Bring the two strands down and two more pieces of Blutack at the ends.
4. The strands cross, one strand loops under the current tile, the other slips under the adjacent tile as per the typical pattern in the other articles.
5. Both strands then follow up the track of the next tile. Be very careful where the loops go. It's easy to make a mistake.
6. Blob two more pieces of Blutack to the ends of these tracks. Only the five pieces of Blutack are required. You'll be able to handle the final tile.
7. Bring the loops down across the third tile. Be careful which direction your strings go.
8. Slip the two ribbons at the end of the loop. Use the thumb and forefinger of both hands to grip the ribbons, while bracing the tiles with your other fingers. Can be tricky but you get used to it. Use the ribbons to do some slight stretching.
9. Then draw the edge of the loop over the lip of the tile. The loop will snap into place.
10. Then you can pull the trapped ribbons out. Then onto the next loop.
That is the basic technique. Beyond that, try to join three tiles at a time then attach all together. Test each completed set of three tiles as you go as it is very easy to make a mistake. Always keep a complete magic nearby to compare the stringing.
哪位高手有空翻译一下
8片魔板的绑法
摘自：http://twistypuzzles.com/articles/magic-restringing.shtml
注：红线是指线在魔板上面，蓝线是指线在魔板背面
The new plans by Justin Asbury are away! Hook in and knock yourself out. The red lines represent the string on top of a tile, and the blue is the string passing underneath the tile.
If you want to try and locate the joiners for the fishing wire, you can try the following suppliers. If anyone gets hold of some, let us know:
Powerbait.comScottyusa.com
The following diagrams will show you how to re-string your magic. You will need a Each diagram below is for a single, continuous strand of fishing wire.
As stated before, the red line is the string above the tile, the blue is the string passing beneath the tile.
4x2 Magic, string 1 of 8:
  |
 |
|
|
4x2 Magic, string 2 of 8:
  |
|
|
|
4x2 Magic, string 3 of 8:
|
|
|
|
4x2 Magic, string 4 of 8:
|
|
|
|
4x2 Magic, string 5 of 8:
|
|
|
|
4x2 Magic, string 6 of 8:
|
|
|
|
4x2 Magic, string 7 of 8:
|
|
|
|
4x2 Magic, string 8 of 8:
|
|
|
|
[此贴子已经被作者于2007-6-22 11:36:21编辑过]
16 片的魔板：
12片魔板
24片魔板[em02]
八片魔板的一种造型：
呵呵，鼓励大家这次多买魔板。
呵呵，鼓励大家这次多买魔板。
不是不想买，是RMB的问题~！
没办法~！~！~！
[em06][em06][em06][em06]原来如此！多谢多谢！我的魔板断线后，用去近两个线团试验，再用尼龙丝绑，基本好翻。还有点小问题，却总是解决不了。看了那“”红蓝“绑法图后，我将再重绑试试。
我还把原来的三环图换成了奥运五环，翻到最后原分开的五环”变为“扣起来了。还自做了两、三、四、六片的魔板，配以龟兔赛跑，孙悟空变大鲤鱼、”人人为我“变”我为人人“、12生肖图等。但没刻线槽，容易脱线。
乌木 2005－2－7
[此贴子已经被作者于2005-2-7 15:44:25编辑过]
原来如此！多谢多谢！我的魔板断线后，用去近两个线团试验，再用尼龙丝绑，基本好翻。还有点小问题，却总是解决不了。看了那“”红蓝“绑法图后，我将再重绑试试。
我还把原来的三环图换成了奥运五环，翻到最后原分开的五环”变为“扣起来了。还自做了两、三、四、六片的魔板，配以龟兔赛跑，孙悟空变大鲤鱼、”人人为我“变”我为人人“、12生肖图等。但没刻线槽，容易脱线。
乌木 2005－2－7
趁重绑魔板之时，索性换图，原三环改为五环。
[此贴子已经被作者于2006-1-19 16:56:47编辑过]
附件: [魔板的 拆装 和换图案] fT9g8hvp.jpg (2006-1-19 16:51:08, 21.21 KB) / 下载次数 56附件: [魔板的 拆装 和换图案] SdJm15Cv.jpg (2006-1-19 16:52:41, 19.56 KB) / 下载次数 53附件: [魔板的 拆装 和换图案] OyQyZ9rZ.jpg (2006-1-19 16:52:41, 18.55 KB) / 下载次数 60请判断终态A面该是什么样的，告诉您以下条件：
注：此题我自己也在试做，您认为还缺什么必要的条件，
请提出来。
[此贴子已经被作者于2006-1-19 18:00:50编辑过]
附件: [魔板的 拆装 和换图案] 2w9IvEW1.jpg (2006-1-19 17:35:06, 85.54 KB) / 下载次数 57求 四片魔板的绑法!!
谢谢
[此贴子已经被作者于2006-4-3 9:36:29编辑过]
附件: [魔板的 拆装 和换图案] fkWmRXkJ.jpg (2006-4-3 09:34:59, 37.92 KB) / 下载次数 63附件: [魔板的 拆装 和换图案] Gf0CsSz8.jpg (2006-4-3 09:34:59, 41.14 KB) / 下载次数 59附件: [魔板的 拆装 和换图案] mTFNsUkN.jpg (2006-4-3 09:36:21, 39.98 KB) / 下载次数 54附件: [魔板的 拆装 和换图案] CMJHsXHB.jpg (2006-4-3 09:36:21, 39.58 KB) / 下载次数 586块的绑法呢? 12块的绑法呢? 希望都能贴出来.
或者贴出一个总体的绑法规律,就更好了.
再次谢谢了.
绑线规律 英文
2eTTxkIu.rar
(10.91 KB, 下载次数: 161)
附件: [魔板的 拆装 和换图案] 2eTTxkIu.rar (2006-4-26 23:13:52, 10.91 KB) / 下载次数 161http://twistypuzzles.com/articles/magic-super-master.shtml
这个是否16片魔板的绑法？
银子不多啊 看的我心痒痒
| 欢迎光临 魔方吧·中文魔方俱乐部 (http://bbs.mf8-china.com/) | Powered by Discuz! X2 |