shim's Master FTO (Timur Evbatyrov)

grigr

As you all may remember, when I was selling my cast Master FTO, I said I was neither going to build others nor to put it on Shapeways. I did this to highlight its uniqueness and increase the value of the item. And I was really going to keep this promise for the buyer. But Konrad (the buyer) said to me afterwards that he would really appreciate if I made a playable good-turning 3D-printed MFTO (it wasn't a secret that the cast one was not easy to turn) and put the design on Shapeways. He convinced me that I should do this job so that he and others could have the possibility to play with this puzzle.

Well if the buyer does not have any objections, others should not do either.

So I considered the flaws in my previous design and made this full 3D-printed puzzle. It is much more accurate, stable and a little smaller (now it has the same size as a commercially available FTO).

store: http://www.shapeways.com/shops/pequenos

aadxd

黑色贴纸感觉像是空的

tengda

做得太好了，谢谢分享。

42752277

有点像大烟头做的·8角

子坎

十分羡慕楼主的3D打印机......

野 子

还是小，能大点么？看着大气，太小显得抠搜

小七阶

挺漂亮的，不错呀

wyy1998

这结构……彻底无语了，只能看出来是个八轴。
ps：突然想到，把蓝蓝那种八轴八面体的结构扩大，应该就是这个魔方了。

MKP魔方收藏家

goodgoodgoodgggooooooddd！！！