[转帖]Fast Edge Cycles

彳亍

http://games.groups.yahoo.com/group/blindfoldsolving-rubiks-cube/message/1568

跟我的 三循环同时解决位置和方向 殊途同归  ：） 

先转过来，有进展随时报告。

Hey guys, I've been working on getting my BLD times down a lot.
I'm learning new things daily, and working on concepts.

The fastest Cycle I could come up with was this ... seriously too.

M'U2MU2, and any isomorphic M Slice Case thereof.

This would be a two step for solving the edges EO and EP.
It is possible to do direct EP, but setups take a little more
thought.

Dir = Direct = No EO
Indir = Indirect = An EO step
2x = Permuting 2 Edges per Cycle
Slice Cycles can be used for, Dir, 2xDir, Indir, and 2xIndir on the
edges. I've achieved sub-10 BLD w/ 2xIndir, I'll try the other
three options.

Ahhh I think I just realized how this can work. Well, we're doing
all these cycles, if we do Direct or Indirect Solving piece by piece,
It is possible to solve the edges with this method:
Set, M'U2MU2, Reset
Set, U2M'U2M, Reset
Set, M'U2MU2, Reset
Set, U2M'U2M, Reset
etc.

Anybody interested, please look at it. Thanks

Later,
Daniel Beyer

老沙

原帖由 小哲哲 于 2011-5-13 09:56 发表 老帖都顶出来了，不过也要想前吃醋前辈致敬啊@@

吃醋读起来好麻烦。我把那个记成'行hang'

小哲哲

老帖都顶出来了，不过也要想前吃醋前辈致敬啊@@

老沙

原帖由 warl0rds 于 2009-5-9 21:51 发表 06年9月彳亍 已经开始研究位置方向一块还原？？  元老

yh
盲拧的发展历史。。。。。。。。。。。。。

warl0rds

06年9月彳亍 已经开始研究位置方向一块还原？？  元老

彳亍

QUOTE:

以下是引用ggwfnh在2006-9-12 10:59:58的发言：

现在方法变了嘛？/不是先还原棱块。是先还原的角块。

当然角块的还原次数是偶数次，不用做，

但是奇数次的话不是还要做一个奇偶校验。?????

或者最后来直接交换UL和UB棱   ??
  但是不可能出现这种情况。？？？？？？？

先角先棱都没所谓的。奇偶校验肯定有，有可能需要影响一对棱

yingmu

学学大烟头也来研究研究

[Scramble] U F L2 D2 F U R B F2 U' D2 F D L F2 U' L U R2 U2 B R' D2 R L2