Gan2简评

Wilson64233

应该可以大大减低黏滞的可能吧....?

chao1987109

不知道什么时候量产....

smallsky

棱块加弹簧什么意思？听起来很神奇！GAN说会有一小部分上市，求价格！

gan

可以上淘宝找找，搜 淦源， ganspuzzle， GAN魔方 等，不过看清楚是1号还是2号，价格不同的

Crazy Tien

期待这个上市，估计这又是一款神器啊

ll86930

看着就想要 不知道什么时候能量产  希望能早些进入我的口袋里。。

lhy1975

入手一个黑色收藏，呵呵！

894058936

原帖由 S轨迹K 于 2011-5-10 19:08 发表
这个棱块加弹簧的创意也许很多人想过，但只有GAN做出来了，这不知可不可以和孤鸿的内圆构造媲美，但在我看来是很神奇的……

哦 到时要买 自己亲自试一试手感 谢谢

revolt

角块的设计是相当有创意

daniel0731ex

Holy crap this thing is a work genius!

I actually doubted the effect that the flexible edge piece have on improving corner cutting, but after seeing the corner pieces, I realized that this design would actually eliminate reverse-cutting lockups completely.

The only source of lock-ups when attempting a reverse corner-cutting is the outside cubies catching on each other; edge-to-edge and center-to-corner.
But for the interior section, it makes no difference to them whether you are doing a foward or reverse cutting; they "open up" and glide over each other either way.
What this means is that, if you eliminate the only factor causing the locks (the outside cubies "pushing" against each other in reverse-cutting), the cube will tolerate reverse misallignments even at extreme angles.
In addition, the profile of the corner piece (I'll explain how that works later, it's have something to do with the center piece) combined with the flexible edge cubie will allow all angles of foward-cutting to be almost indifferent from each other (meaning that it takes approximately the same amount of force to cut 1/2 cubie as to cut 1 cubie) except for minor difference due to the spring's nature (F=kx).

This concept, if refined and cleverly engineered, will effectively eliminate any lock-ups possible.

[ 本帖最后由 daniel0731ex 于 2011-5-18 01:53 编辑 ]